SR6 Alpha1 Fan Base
Added 2021-08-04 05:52:27 +0000 UTCNOTE: There is a good chance we will see the SR6 Beta soon, and these parts are not going to be compatible as they require my Nutted SR6 Base part, which I've included in the zip.
NOTE: There is a good chance we will see the SR6 Beta soon, and these parts are not going to be compatible as they require my Nutted SR6 Base part, which I've included in the zip.
40mm, 50mm and 60mm fan mounts without losing "headroom" for collisions. The air enters through the back ports of my Nutted SR6 case. Fan should be 10mm thick. 15mm thick fans physically fit, but will almost certainly perform worse than 10mm thick fans due to a lack of clearance with the bottom of the SR6. There's spots for 4x M3 hex nuts and screw holes for 4x M3 x 14mm screws, but this is just a fan, you could just as easily glue it in.
You want your fan to be blowing inwards, and you can run the cable up and into one of the two ports on the back of the Nutted SR6 body.
This has eight total nut pockets for M4 nuts. If you have long M4 screws (30mm+) then you can probably sandwich this between your usual mount and the SR6 and skip adding nuts. Otherwise, you can insert nuts into the pockets and insert screws from both sides. Due to reasons, I needed to leave 0.2mm of plastic between some of the screw holes in the M4 Nut portion. Stab it with a screwdriver if you need to use them. "nut filler.stl" is a pressure fit plug to keep the nuts from falling out.
Finally, there's a little gap for a drop in panel if you'd like to mount a potentiometer or switch for your fan. It measures 17mm tall, 84mm wide, and 3mm thick.
