Angle adjustment bracket for mount
Added 2022-03-16 12:40:16 +0000 UTCSorry about the bad image quality, didn't realize my lens was dirty.
I'll probably reduce the amount of fasteners this angle bracket uses as it's extremely rigid as is. This allows for 180+ degree angle adjustment as well as any amount of height adjustment. Replacing some of the fasteners with plastic that runs in the extrusion channel should make it easier to adjust. Right now it binds up a bit when sliding due to the multiple t-nuts used on each side.
Next up is angling the clamp handles 40 degrees outward for ease of use and better clamp force in the middle, which is printing now. After that I'll be trying it out to see what issues remain. Printing a vesa bracket isn't optimal, but running some screws out to the edges really stiffens it up.
Video of the model to clarify: https://streamable.com/30imtv
