Cassette keychain double 📼
Added 2023-03-02 02:44:56 +0000 UTCThis is certainly not entirely an early access, as the cassette is attached in the last post, albeit as a beta version.
There are no special changes, use 0.2 mm layer height or finer. No supports, PLA recomended.
I also made a case. A few iterations and everything is ready 😬.
Something is clearly missing on the case. Somewhere at home I have lost a suitable sticker, it remains to fantasize in fusion360 👩🦰🐢
Since this post will be open, I will repeat the process of changing reels again.
1. As you can see, the reels are made in the form of gears. Press the reels with force.
2. I inserted the reels from the edge to the center.
I repeated the procedure many times, the body did not deform, except that scratches from the gears appeared. Be careful, take care of your fingers) ❗👈
3. Make sure that the teeth enter.
4. It is better to print Cassete_dbl_body.stl (without reels) separately from the gears, the inner surface will be cleaner. Silicone grease Super Glidex can also be used here. Then you need to rinse under a stream of water.
As in the first version of the keychain, you can find an Easter egg. Since there are two protective tabs, one has a smile 🙂 in the other heart 💖
I added this design to the "3dmodels" folder 🥳
I think this is enough designs in fusion360, it's time for me to go back to zbrush 🤘
