Sitting Pumpkin Buddy (Hidden Legs)
Added 2022-10-08 14:08:37 +0000 UTCThis version of the Pumpkin Buddy has hidden legs! This 3D print is a fun halloween decoration/little accessory for your office setup that will bring good vibes!
Simply print one out, lift up to expose the legs, tilt back at an angle, and the Pumpkin Buddy is now chilling in a sitting position!
Printed at 0.2mm layer height
Comments
I like the way you think lol
Gary Greer
2022-11-22 22:06:07 +0000 UTCCan you make it like a christmastree? :D It's so sweet.
Mikael
2022-10-16 19:42:15 +0000 UTCNo supports needed!
Matthew Moscato
2022-10-13 23:29:08 +0000 UTCAre supports necessary?
Spencer Diniz
2022-10-13 23:28:34 +0000 UTCI would like to see the legs similar to the Zou ghost instead of the ball at the top of the leg since they can rotate 360 degrees. The ghost uses a square I think
Brandon Wieber
2022-10-12 23:00:15 +0000 UTCPrinted this in flashforge flexible pla (TPU) and came out AMAZING
Brandon Wieber
2022-10-12 22:58:50 +0000 UTC
