Print-In-Place Treasure Chest
Added 2023-10-11 02:47:59 +0000 UTCThis treasure chest design prints in place without any support material or assembly required! Fully functional right off the build plate!
Locking mechanism design allows the lid to close and it won't open unless slight pressure is applied to the top of the keyhole.
Printed at 0.2mm layer height
Comments
I printed three of them and had it happen to one of them
PNWPrintedIdeas
2023-10-13 20:52:47 +0000 UTCI printed this and it turned out so nice, but the tab on the top half that locks into the bottom broke off almost right away. Did that happen to anyone else?
Laura @ Prism3D Creations
2023-10-13 20:07:38 +0000 UTCCan you Show us this in Fusion?
Daniel Baumeister
2023-10-11 16:59:53 +0000 UTCwhat if you put small ledge across the left and right of the bottom about half way up, then a tray could be designed that would drop in/out for more organization? Jewelry boxes often have trays like that. :)
Richard Kelly
2023-10-11 12:32:49 +0000 UTCThank you so much! I have it printing right now.
Richard Kelly
2023-10-11 12:19:50 +0000 UTCCan you scale this?
Damian daniels
2023-10-11 03:34:11 +0000 UTCI thought you were developing a lock and key mechanism..
Uttamkumar Patel
2023-10-11 03:05:31 +0000 UTCLooks Great. Can you this in Fusion?
Daniel Baumeister
2023-10-11 02:53:33 +0000 UTCHeck Yea!
ItsEggo
2023-10-11 02:51:44 +0000 UTC
