Box Style Chest (Key Lock)
Added 2023-10-17 19:02:36 +0000 UTCPrint in place Box Style treasure chest that doesn't require any support material or assembly! Fully functional right off the build plate!
Locking mechanism allows the lid to lock shut and can only be opened with the 3D printed key!
Printed at 0.2mm layer height
Comments
I've tried starting this twice and always end up with all of the corners warping. I've used anti warp tabs but they don't help. Any other settings? I printed the first two at 180mm/s. Don't want to go any faster as it may warp even more. But if I get too low, I end up with a 24 hour print. Any suggestions?
Barry Beach
2023-11-16 17:06:11 +0000 UTCdont think it would be as durable in a 2 piece design the way the hinge is. the lid could be made shorter if you print that side with supports or if he designed supports in the model it self.
Kyle Rogers
2023-10-20 23:34:47 +0000 UTCim down to 6 hours but i am printing at 250mms, i could do 4 hours at 500mms but could effect the locking mechanism. i have an elegoo neptune 4 printer but depending on what printer you have you could be printing as little as 50mms. Increase your layer height slightly, maybe to .22 or .24. you should be able to print at around 60-70mms comfortably on a standard ender if its dialled in. i would reduce infill to 8% and infill type to lines as this would still give plenty strength. good luck :)
mikey roberts
2023-10-19 06:52:27 +0000 UTCanyone get this down any amount of significant time for print time? i got under 12 hours with 2 walls triangle 15% infill but havent printed yet to see
Hell Houndz Productions
2023-10-19 02:09:26 +0000 UTCLove the model by the way!
TheEightBitDad
2023-10-17 19:20:37 +0000 UTCWould it be possible to shorten the lid and print in 2 parts where the hinges clip together?
TheEightBitDad
2023-10-17 19:20:27 +0000 UTCSo rad!
PNWPrintedIdeas
2023-10-17 19:04:44 +0000 UTC
![Jive Faury [SDD Lab]](https://samuzai.com/istorage/43236.jpg)
