Final release of June! Pre-supported files + Arena end cap
Added 2020-06-30 19:48:10 +0000 UTCHere we go! As you can see, the horses for the cart and the elf variant have been pre-supported for resin, as well as two empty hands. Also available not supported.
Also added a last minute end cap for the Arena, if you want walls to not connect together.
Take care everyone, and see you VERY soon for July!
Comments
@Jake Knight - Great question! My method for creation of supports is as follows: 1) Load model into PrusaSlicer, orient and then generate supports. (I use modified values from default). 2) Check the model over for any obviously wrong / unnecessary supports. 3) Export model, with supports, slice via ChiTuBox and then load into Photon File Validator for verification of island removal. 4) Ignoring islands less than 3 pixels, I then go through and make sure every island is supported via manual supports in PrusaSlicer. This continue until no islands are left. 5) In the event that I cannot support something via PrusaSlicer, like the chin on the gladiator above, I then go into ChiTuBox to add remaining supports. The model is then test printed by me, where I then perform one final look over (I'll occasionally realize something needs adjusted or more supports needed added/removed once I have the print in hand) before the models are released. I hope that helps!
Nick Porterfield
2020-07-01 13:24:13 +0000 UTCJust curious are these prusa-slicer auto supports or has there been manual adjusting / testing after the fact?
Dynamic Prints Studio
2020-07-01 00:29:24 +0000 UTC
