3 leg jabba tray complete.
Added 2018-02-04 11:09:49 +0000 UTC3 leg Jabba tray printed, tested and I’m happy with the fit. Pics are unfinished raw PLA bronze filament, incorporates magnets on all trays for accessories which won’t come off when moving. Uses M4 bolts and square nuts throughout. Tray is solid and holds weight with enough flex to prevent damage. Files and instructions for both 2 leg and 3 leg available In the early bird Patreon share. Instructions for 2 leg and 3 leg coming (although instructions are virtually identical. ). Files shared via public folder in a couple of weeks as always.
Comments
OK Thanks, I am starting to print this tomorrow.
Phillip Williams
2018-02-06 20:41:27 +0000 UTCAlso bolt lengths are different for 3 legs, I need to complete the instructions.
Michael Baddeley
2018-02-06 05:26:15 +0000 UTCThe leg build is the same for left and right. 1a is the main frame and 2a is the face on the other side of the leg. It screws / glues in. They’re cut differently for strength, I don’t put cut points in the same place.
Michael Baddeley
2018-02-06 05:25:24 +0000 UTCSorry!! Will fix that, apologies.
Michael Baddeley
2018-02-06 05:22:42 +0000 UTCI read the Instructions which get a A+ as you have listed parts but I didn't get a mention in the Supported section :
Phillip Williams
2018-02-05 23:06:56 +0000 UTCUnder the wip 3leg leg-3legs , whats the difference between leg1a and leg2a , are they left and right and if so why are they cut differently , thanks again.
Phillip Williams
2018-02-05 22:31:38 +0000 UTCI think around 2 reels, maybe into a third. Really difficult for me to judge as I have loads of reprints while I get the design right and I printed the 2 and 3 leg version.
Michael Baddeley
2018-02-05 21:56:25 +0000 UTCHow much filament did you use to make the tray?
Phillip Williams
2018-02-05 21:55:00 +0000 UTCso much goodness in one photo
Geoffro / Hex3D
2018-02-04 23:05:20 +0000 UTCAwesome !!!
Orpheus1103
2018-02-04 11:13:15 +0000 UTC
