Update: Doors as a single print
Added 2018-04-01 21:06:24 +0000 UTCI've added doors as an experimental single print option for the doors. They're in the Body - Doors folder. You'll have to experiment how it print them. I suspect flat on the "inner" side with supports will be the best way.
Comments
I think it will print just fine with a raft. I printed the long door on its edge with support only on the very bottom so the lip of the door is touching the bed. (The door is perpendicular to the bed laying on its long edge). I would put a screen shot, but I don't see how to do that. My Taz 6 is tied up with an outer foot shell for another 8 hours. When that is done, I'll try my print with a 5mm raft and let you know for certain.
Timothy Hebel
2018-04-02 21:10:57 +0000 UTCI’ve added an experimental cut. Using the 45 degree angle like the side pockets, should give a two part print, no seam and no support?
Michael Baddeley
2018-04-02 18:34:06 +0000 UTCWhat good timing. I was just about to print the doors. I printed Door1 one and it worked fairly well. I had the edge curl up a bit I'm going to do the other doors with a raft.
Timothy Hebel
2018-04-02 17:04:36 +0000 UTC
