A print of beauty
Added 2018-09-17 04:00:49 +0000 UTCWayne’s printed dome from the MKIII files, lovely print!!
Comments
The MKIII domes do have all panels in place. The v2 dome have the opening panels so there’s options. I may do the MKIII in the future with opening panels but it’s not critical as the v2 works fine.
Michael Baddeley
2018-10-19 06:29:50 +0000 UTCAre the dome panels printed in place? I printed the 200 version in PETG, and I'm planning to have the panels open/close.
Terry Dossey
2018-10-14 23:19:42 +0000 UTCWas there a filament change required? How much filament did it take? I need to upgrade my CR10S 3
2018-09-20 16:35:16 +0000 UTCI printed at 8% infill, and no problems with strength.
Peter Richards
2018-09-18 00:01:31 +0000 UTCLooks like a CR-10 S5
Peter Richards
2018-09-18 00:00:56 +0000 UTCwhat is the 3D printer you used for this wonderfull print ?
2018-09-17 08:35:38 +0000 UTCAh, just seen he used PLA+ but would work fine with PLA
Michael Baddeley
2018-09-17 04:51:07 +0000 UTCAlso was printed with ESUN PLA +
Wayne Vyner
2018-09-17 04:48:00 +0000 UTCHi guys. Settings were 0.2mm layer height, 10% infill, speed 36 , no supports and raft. Took aprox 216 hours.I did put a few dobs of hot glue along the inside to edge hold it onto the raft. It’s only a narrow edge and didn’t want to risk it coming off the build plate later down the track.
Wayne Vyner
2018-09-17 04:47:27 +0000 UTChoping to start this one later in the week!
2018-09-17 04:25:40 +0000 UTCNo support, .4 nozzle and I assume PLA.
Michael Baddeley
2018-09-17 04:23:18 +0000 UTC
