Cha hae last wip and scale question!
Added 2024-05-21 16:02:25 +0000 UTCHi guys, last update on the model. Just a few little details here and there to finish, but I'm practically done. I'll take the next few days to refine the model and start preparing the fittings!
But I have a question for you, since I'm always asked what scale the model is. How tall would you like it to be? And what scale would that correspond to?
Thanks everyone, I hope you like it!
Comments
Oh thank you, i'll try it!
Il_Paddyy
2024-05-22 05:26:43 +0000 UTCYour skull knight and most chainsaw man models youβve released have been in 1:8 scale. Personally I donβt care what scale they are at as long as theyβre in a specific scale so its easier to re-scale. I use sanixβs scale converter tool is very helpful ( https://sanix3d.com/scale-converter-page/ )
Pipoxo
2024-05-21 20:25:54 +0000 UTCjin woo if I'm not wrong it should be around 24 cm, because the whole model including igris is 32, so yes more or less 24...
Il_Paddyy
2024-05-21 18:50:32 +0000 UTCOk thanks everyone
Il_Paddyy
2024-05-21 18:49:38 +0000 UTCWhat scale was Jinwoo? I haven't had the chance to print him yet
Daniel
2024-05-21 18:42:36 +0000 UTCi think you should keep same as sung jin woo.
Marcio Chuang
2024-05-21 17:28:42 +0000 UTCLike what nono said, keep it consistent with your Jin Woo. But I mostly print in 1:6 scale π
patrick frani
2024-05-21 17:14:27 +0000 UTCI concur. I also print at 1/6 99% of the time. Since scale is relative, you just have to take the height of the percent and find multiply that by 1/6.
Tsz Sui Lo
2024-05-21 16:52:06 +0000 UTCI print most of my models in 1:6 scale. For me, it's the perfect compromise between space and having good detail. Cha's height is said to be between 160-170cm which would put her height at 1:6 around 26.6-28.3cm not including the base.
Daniel
2024-05-21 16:35:30 +0000 UTCLike Sung Jin Woo, like that it's consistent :)
Nono
2024-05-21 16:20:24 +0000 UTC
